Solid Steel Cable Pulling Sheave Pro Grade Workhorse With Low Friction Bearing And Powder Coated Finish Beat Rust Deformation Under Heavy Loads Ideal For Rigid Industrial Roller Pulley Applications On Rough Sites

Prezzo normale 429,95 $ Prezzo in offerta889,00 $risparmi $459,05
Product ID: 1229-1335
UPC:





Heavy Duty Steel Cable Pulling Sheave With Triple Roller
✔️ 5 Ton Load Rating Includes Safety Shackle For Tough Cable Runs

This single heavy duty cable pulling sheave uses three smooth rollers to cut friction when you route thick wires through ducts or across poles. Workers deploy it at electrical job sites, telecom fiber runs, and underground utility projects. You get a solid steel frame that handles heavy loads without bending or rusting under wet conditions.

✅ Three polished stainless steel rollers spin freely inside sealed bearings
✅ Thickened solid steel body resists rust and deformation under pressure
✅ Rated for five tons of tension with a matched safety pin shackle
✅ Simple bolt assembly lets you swap setups fast on active work sites
✅ Fits power lines, communication cables, and fiber optic bundles alike
Diametro della ruota 39 inches Width 63 inches
Diameter Metric 100 mm Width Metric 160 mm

💡 What does a cable pulling sheave do on a job site?
It basically changes direction so you can drag heavy wires around corners without dragging them straight. These rigs are super handy when you gotta run lines through tight conduits.
- Rolling pins take the heat off your hands and protect wire jackets from scrapes.
- Heavy duty steel mounts hold firm under five thousand pounds of draw tension.
- You get smoother pulls and quicker finish times across every utility project.

✝️