Heavy Duty Pneumatic Cooling Sprayer For Lathe And Mill Machines High Flow Cutting Fluid Atomizer Smooth Air Powered Oil And Water Feed Pump Built Like A Tank For Shop Grind

Regular price $109.95 Sale price$248.00you save $138.05
Product ID: 1237-2303
UPC:





Pneumatic Cooling Sprayer Reduces Lathe Mill Tool Wear.
✔️ Pneumatic sprayer allows adjustable flow and keeps coolant clean overall.

You can mount this air powered sprayer directly onto lathe or mill fixtures to spray atomized cutting fluid exactly where the blade meets the metal. The design pulls pressurized air from your shop compressor to run silently without cords, working well for sawing machines, feeders, and heavy grinding setups while the integrated filters block grit from clogging the nozzle.

✅ Wide application supports lathes, mill tools, saws, and feeders.
✅ Conservative fluid usage cuts waste through precise spray control.
✅ Integrated non-return valves stop backflow and protect your setup.
✅ Internal filters capture particles to maintain clean spraying action.
✅ Simultaneous cooling, lubrication, and chip removal boost throughput.
✅ Lower tool wear and faster cycle speeds save money on parts.
✅ Easy airflow and spray adjustments simplify operation daily.

💡 What is a pneumatic cooling sprayer good for in a busy machine shop?

This handy pneumatic atomizer delivers sharp, targeted mist that cools workpieces and washes away swarf without soaking your floor. The system runs off standard plant air lines, so you can mount it on almost any bench drill or vertical mill without hunting for electrical outlets. Adjust the flow knob on the top to tweak the droplet size and hit the right balance between keeping cold cuts and saving expensive synthetic lubricant volumes.

- Compressed air drives a mechanism to push fluid through a tiny orifice, creating a fine cloud that blankets hot surfaces during fast cuts.

- You gain better visibility into the cut line because the mist clears smoke and chips away immediately while leaving minimal runoff residue around the table.

- The non-return valve stops fluid from dripping back when the air cuts off, preventing messes on the spindle nose and keeping the coolant level stable overnight.

✝️