Heavy Duty Remote Wiring Harness Wireless Strobe Switch 12V 20A Rocker Relay Kit For Trucks And Jeeps Quick Plug And Play Install No Drama Guaranteed Rock Solid Build

Regular price $65.95 Sale price$161.00you save $95.05
UPC:





Wireless Rocker Relay Kit For Strobe Lighting On Trucks


✔️ 12V Switch Gear Kit With Three Fuse Guards And Long Leads

This heavy duty remote lighting kit gives you direct control over strobe bars without reaching under the dash. You mount the rocker panel inside your cab while the twelve foot wire reaches out to the roof rack or grill. It runs smoothly on most twelve volt jeeps, ATVs, UTVs, boats, and trailers that pull emergency or work lights.

✅ Two separate controllers show bright red and green indicator lamps
✅ Tap four working modes like steady on fast flash and slow flash
✅ Handle up to three hundred watts across multiple light setups
✅ Safety relay blocks current spikes while protecting sensitive electronics
✅ Comes complete with mounting hardware and a printed hookup guide

💡 What is the best way to wire a heavy duty strobe switch harness onto older pickup trucks?

You run the main power feed straight through the integrated relay block to bypass fragile dashboard switches. The pre cut leads save hours of cutting back and stripping fresh wire on stubborn chassis grounds. Your custom flash timer handles rapid sequences without draining the starter battery during cold mornings. Just double check terminal tightness after hitting rough gravel roads.
- Size the inline blade fuses to match the exact amperage draw of your rooftop LED setup
- Mount the rubber boots directly over stripped conductors to stop corrosion near salt springs
- Run parallel ground straps across clean painted surfaces when original bolt holes rust shut
- Verify the controller responds instantly before routing wires through existing engine bay channels
✝️