Premium Billet Aluminum Hood Riser Kit For Honda Civic CRX Integra 7 8 Inch Blue Anodized JDM Spacer With Extended Bolts To Drop Heat On The Street And Dial In That Sick Fitment
✔️ Aluminum hood spacer lifts rear 7 8 inch blocks engine bay heat
You sit this aluminum spacer pair between your factory hinge point and the metal panel to tilt the front up slightly. You gain cleaner airflow straight into the intake tube while you idle in town traffic. Builders drop these on 88 to 00 civic projects to fight power robbing heat soak every weekend drive you take.
✅ Rigid 6061 billet alloy body withstands daily vibration without flexing out of alignment✅ Lifts the leading edge roughly seven eighth inches for optimal coolant flow direction
✅ Includes four elongated zinc bolts designed to clear thick original factory mounts
✅ Tough blue oxide layer shields the metal from road grime and summer sun exposure
✅ Direct bolt on install works seamlessly on del sol frames and acura integra rails
💡 Does increasing the standoff distance across the hood hinges actually reduce power robbing heat soak on daily drivers? It is worth the tweak because moving that sheet metal off the flat deck channels cool outside air right into the radiator stack. Here is why swapping in a fixed spacer makes sense for your build:
- Wider intake aperture improves static pressure distribution across the fin array during low speed runs
- Elevated cowl geometry stops radiant heat bounce back into the open cold air ducting path safely
- Solid aluminum composition prevents thermal expansion that normally warps stamped parts over seasons