Top Notch 3 Channel Relay Module With Optocoupler Isolation For Arduino Raspberry Pi Esp32 Smooth Plug And Play Home Automation Kick Some Serious Voltage 5 Volt AC DC High Power Setup
3 channel relay module with optocoupler for Arduino
✔️ 250V AC 30V DC capacity 7A per pin 63x42x18mm frame
You can safely switch heavier loads straight from cheap boards like Arduino or ESP32. This three station switching board keeps your brain chip safe while you run lights, small motors, or basic home gear from a single setup.
✅ Built in optocoupler shield stops high voltage from ruining your micro controller✅ Draws just five milliamps so even weak sensor pins handle it easily
✅ Handles up to seven amps across three separate circuits at once
💡 Why choose a three channel optical isolated relay module for hobby projects?
This design protects your processor while letting your script manage bigger gear reliably.
- Optocoupler separation blocks backflow spikes that damage expensive micro controllers
- Five milliamp drive requirement frees up precious GPIO pins on cheap dev boards
- Three independent switching paths keep your wiring tidy inside small plastic enclosures